Taper sleeve pulley disassembly skills

After a long period of operation, the pulley will have a certain degree of wear and tear, and it is necessary to consider replacing it at this time.

2023-09-28

2023

09-28

What should be paid attention to when installing rubber sealing ring?

The cross section of the rubber sealing ring is mostly circular. Compared with the frame oil seal, the structure is simple, without frame and self-tightening spring, which depends on the ductility and flexibility of the rubber itself. If the installation is unreasonable, it will cause sealing failure, improve the wear of the operating parts, and even burn out the shaft and other major failures. Therefore, the installation of rubber seals should pay attention to the following:

2023-09-28

2023

09-28

How long can your pulley last? Pulley routine maintenance will take longer!

In the long-term use of the taper sleeve wear is an inevitable problem, so we have no way to reduce wear and prolong the service life of the pulley? Here is a brief introduction to the daily maintenance of the pulley how to do:

2023-09-28

2023

09-28

How to adjust the belt conveyor deviation?

How to adjust the deviation of the belt conveyor? How to understand "running tight but not loose, running high but not low, and not running front after running"

2023-09-28

2023

09-28

Pulley fever do not panic! After reading, you will know the reason.

With the rapid progress of industrial technology, automated production has been developed, making the efficiency of enterprises more and more high. However, with the gradual liberation of employee labor, the frequency of use of mechanical transmission is increasing, and the demand for transmission hardware such as pulleys is also increasing.

2023-09-28

2023

09-28

How a tapered shaft is connected to the coupling

Generally, the tapered shaft end is threaded, and the coupling is fixed on the shaft with a nut. The TⅢ output shaft of the HG5-251-79 frame is matched with the shaft head of the agitator. The end of the output shaft is a special shaft head with a tapered front end and a threaded rear part, which is matched with the tapered hole and the internal thread of the shaft head of the agitator.

2023-09-28

2023

09-28

Inspection items and maintenance methods of coupling

1. inspection: 1, check the coupling body for cracks.

2023-09-28

2023

09-28

All kinds of couplings, 7 suggestions to help you choose correctly, with 8 operation skills

In practical application, the coupling can be divided into heavy, medium, small and light according to the transmitted torque.

2023-09-28

2023

09-28

Timing pulley daily maintenance needs to pay attention to these three aspects.

The synchronous belt wheel will wear out after being used for a long time, and the phenomenon of shaking and sliding will often occur during long-term operation. If the timing pulley is not checked regularly, it will cause damage to the machine for a long time, and it may be directly damaged in severe cases. Therefore, in our daily use, we must regularly check the timing belt wheel. Then the iHF combined gear tells you what aspects should be paid attention to in the daily maintenance of synchronous pulley?

2023-09-28

2023

09-28

What are the plane pulley model? detailed explanation!

Pulley size specifications and models are as follows: 1. Belt drive mainly includes: flat belt, V-belt, synchronous toothed belt three, three kinds of belts have national standards, but pulley due to the transmission ratio, power changes, there is no fully corresponding national standards or national standards, can not cover all the content, but the national standard to determine the scope of selection, design methods and other content.

2023-09-28

2023

09-28